KMI Press to Dry Machines
KMI 1300 TP-50
Production: 50 Kg per hour
Specification:
Machine Model No.: TPM-1300tp
Machine Dimension L: 7000mm by W: 2250mm by H: 3700mm, Weight: 13,000kg (28,660lb).
Direct hot press technology, no drying oven required.
Construction Material: High Strength Carbon Steel with heat treatment is for structure.
Stainless steel for all wetted part.
Effective Moulding Area L: 1300mm by W: 750mm by H: 120mm.
Horizontal travel length: 1750mm; Vertical travel length: 380mm.
One movable lower forming platen driven by inverter motor.
Three connected upper movable platen with 2 dimensional directions driven by servo motor.
Two lower vertical movement pressing platen driven by hydraulic pump.
1st Hot Press force: 16 tons, 2nd Hot Press force: 25 tons.
Automatic two water bars cleaning mechanism for deckle ring edge wash and mesh cleaning.
Water pressure: 3 bar for wash; 15-20 bar for mesh cleaning.
One Forming Tank Recirculation Pump.
TFT touch-panel user interface with integrated control panel.
Average pulp consumption: 30~50 kg/hr (it depends on the characteristic of product)
Heating element: Heater Cartridges by electricity.
Equipped with special cooling system designed preventing from thermo-expansion of based plate.
Stable air tanks for forming platen and pressing platen.
Control Components:
AB / SIEMENS
All pneumatic parts: FESTO (German)
Hydraulic unit: YUKEN (Japan)
Servo motor / HMI / PLC control: Allen-Bradley with remote trouble shooting via the internet.
Electrical parts: AB, SIEMENS
Additional fence guarding, safety relay, stop and emergency stop button.
Machine mechanic installed power: 15KW
CE and ISO 9001 standard; UL certified electrical parts & wires
Electricity rating: a) power: 220V/380V/480V, 50HZ/60HZ b) control: 24V/110V/220V
Single process supply
Single Source Pulping System
• Two Pulpers with 21Kw two speed motors @ 500 liters @ 4.2% and 3500 liters @0.6% These pulpers work in sequence. You push the start button and #1 pulper fills up to the pulping level, paper is manually dumped into the pulper . The pulper then pulps for a preset time (on the panel) and then fills up to the final usage level. At this time the pulper drive goes down to low and automatically starts filling the circulation tank and vat. When the tank is empty the cycle starts over (pulper #1) and then the next pulper is selected (pulper #2) which has already gone through the same process as pulper #1. Then pulper #1 and so on. Two pulpers supplying 50 Kg per hour. Pulp is supplied on demand to the pulp circulation tank by gravity.
• One 8,000 litre Stainless steel white water tank.
Requirement/per machine
Maximum installed power for machine & mold (heated by electricity): 340KW